Open topic with navigation

Dispensing FORMULATOR® Screen Builder Plate Designs

If your lab is equipped with both the FORMULATOR and MANTIS, the two liquid handlers can be integrated so that non-precious reagents are dispensed with the FORMULATOR, and precious reagents are dispensed with the MANTIS.

Prerequisites

• You have configured MANTIS-FORMULATOR integration.
• You have sent reagents from the FORMULATOR software to the MANTIS software.
• The plate definition names are the same in MANTIS as they are in FORMULATOR.
• If you are dispensing some reagents with the FORMULATOR, you have already performed this part of the process.

To run FORMULATOR experiment designs with MANTIS:

1. Place the MANTIS chips into the chip pallets, and attach the chip pallet to a chip changer station.

2. Attach the reagent tubes or pipette tips to the ingredient inputs at each chip.

Note: If you are using a pipette tip, you will need to remove the black adapter from the chip’s input.

3. Place the microplate on the plate holder.

4. Drag the reagent name from the Dispense List Designer panel to the corresponding inputs.

Drag Reagent to the Device Control Panel

5. Attach your reagents to the MANTIS chips (if you are using pipette tips, you will need to remove the black adapter from the chip’s input first).

6. Click to start the dispense process or click to run dispense with protocol.

7. The MANTIS will complete your plate dispense design. You may now run Reagent Recovery (optional). When you are finished dispensing, clean the chips.

Related Topics

• Configuring MANTIS-FORMULATOR Integration
• Hardware Overview
• Setting Up MANTIS for a Dispense
• Adding Plate Types to the Plate Type Library
• Priming the Chips
• Recovering Excess Reagent Volume
• Cleaning the Chips

MAC-V41R018	10 DeAngelo Drive Bedford, MA 01730 USA   +1-781-788-0228 support@formulatrix.com publications@formulatrix.com