Dispensing ROCK MAKER® Crystallization Software Plate Designs

MANTIS can be integrated with ROCK MAKER to dispense a plate design you have created in ROCK MAKER.

 

Prerequisites

 

To run ROCK MAKER experiments with MANTIS:

  1. Place the MANTIS chips into the chip pallets, and attach the chip pallet to a chip changer station.

  2. Attach the reagent tubes or pipette tips to the ingredient inputs at each chip.

Note: If you are using a pipette tip, you will need to remove the black adapter from the chip’s input.

  1. Place the microplate on the plate holder. The microplate you use should be the same one you selected in ROCK MAKER.

  2. On the Tools menu, click Hand Scan (Ctrl+H).

  3. Type your experiment barcode number in the Data to scan box (you only need to type the last four digits). If MANTIS successfully reads and validates the barcode, your dispense list, design and settings will display.

The Hand Scan Dialog Box

  1. Drag the reagent name from the Dispense List Designer panel to the corresponding inputs.

Drag Reagent to the Device Control Panel

  1. Click to start the dispense or click to run dispense with protocol. The MANTIS will complete your plate dispense design.

  2. OPTIONAL: If you want to conserve reagent volume, run Reagent Recovery

  3. When you are finished dispensing, clean the chips.

Note: The dispense list imported from ROCK MAKER is configurable after import, however any changes will not be reflected in ROCK MAKER.

 

Related Topics


MAC-V44R120

10 DeAngelo Drive

Bedford, MA 01730

USA

 

+1-781-788-0228

support@formulatrix.com

publications@formulatrix.com