You are here: Software and Instrument Overview : Software Overview

Software Overview

The MANTIS control software is made up of three main panels and a status bar.

MANTIS Interface

 

Section 1: Device Control Panel

Section 1 is the Device Control panel. This is where you execute commands on the MANTIS instrument using the buttons at the top. Here you can also view information about your current plate definition, the total volume per well, and the number of plates to be dispensed. For more information, see Device Control Panel.

Device Control Panel

 

Section 2: Input Control Panel

Section 2 is the Input Control Panel. Use this panel to assign reagents to chip stations, run the wash, prime, and reagent recovery processes, and tell the MANTIS whether you are using Low Volume (LV), High Volume (HV), High Volume PFE, Low Volume PFE, High Volume 3PFE, Low Volume 3PFE, or High Volume Continuous Flow (CF) chips. For more information, see Input Control Panel.

Input Control Panel

 

Section 3: Dispense List Designer

Section 3 is the Dispense List Designer. A dispense list is a list of reagents that will be dispensed to a plate. On the left is where a list of your reagents appear, and on the right is a visual representation of your plate. For more information, see Dispense List Designer.

Dispense List Designer

 

Status Bar

The Status Bar shows you what's going on with your MANTIS at a glance. For more information, see Status Bar.

 

Related Topics


MAC-V47R422

10 DeAngelo Drive

Bedford, MA 01730

USA

 

+1-781-788-0228

support@formulatrix.com

publications@formulatrix.com