Open topic with navigation

Viewing a Plate's Schedule

Automatic imaging schedules are set in the Rock Maker software, but you can verify a plate's schedule or view it from Rock Imager.

To view a plate's imaging schedule and information, right-click a plate on any of the Plates sub-tabs and select Plate Information.

Prerequisites

• The plate is inside the imager.
• You know the plate's project name, experiment name, plate number, dispense date, user name/owner, plate type, plate ID, barcode, location, and/or state.
  

To View a Plate's Automatic Imaging Schedule:

1. Use the Plates tab to locate your plate inside the imager. See Searching for Plates if you need additional assistance.

2. Right-click on the name of your plate and select Plate Information. A new window opens that contains two tabs: Schedule and Information. The Schedule tab contains the plate's entire automatic imaging schedule.

3. When you're done, click OK.

Related Topics

• Searching for Plates
• Automatic Mode
• Plates Tab

RIC-V30R016	10 DeAngelo Drive Bedford, MA 01730 USA   +1-781-788-0228 support@formulatrix.com publications@formulatrix.com