ROCK IMAGER can search your plates for drop locations and save the drop location to memory for quicker future imaging sessions. Occasionally you may need to clear or reset a drop location on a per-drop or per-plate basis. For example, if your drop grows beyond the original drop size, you may need to clear the drop location and run the drop location algorithm again in order to get the best images of your drops.
Note: Whether or not ROCK IMAGER executes the drop location algorithm on a plate is determined by settings in the Plate Type Editor.
Locate the plate using any of the Plates sub-tabs (for further assistance, see Searching for Plates).
Right-click on the name of your plate and select Clear Drop Location Positions.
Locate the plate using any of the Plates sub-tabs (for further assistance, see Searching for Plates).
Right-click on the name of your plate, select Move Plate To and click Imager.
Use the manual imaging controls to navigate to the drop of interest.
Go to the Imager menu and select Clear Drop Position on Current Drop.
|
|
|
| RIC-V38R119 |