. It’s important to wash TEMPEST chips after each use to prevent cross-contamination and dried reagent buildup. Before you begin, remove any reagent tubes from the reagent bottles and direct them to a waste container.
Note: Preferred wash solutions are either 70% ethanol or 10% bleach. You must always wash TEMPEST chips with water after using wash solution.
If you are running a 3-step Wash, the wash solution should go in Wash Station 2, located on the right side of the bottle rack. Otherwise, it can go in Wash Station 1, located in the middle of the bottle rack. You can enable 3-step Wash from the Options Menu.
.
Click a reagent on the Input Control Panel. To select multiple inputs, press and hold the Ctrl key while selecting the desired inputs.
Click the Wash Selected button 
.
Repeat the wash process for each input, until you can no longer see any traces of reagent leaving the chip in the reagent tube.
Note: If you want to clean or sterilize the TEMPEST chips, please refer to the Cleaning the Chips section.
|
|
| TEC-V34R020
|