You are here: Designing Dispenses : Tutorials : Dispensing FORMULATOR® Screen Builder Plate Designs

Dispensing FORMULATOR® Screen Builder Plate Designs

If your lab is equipped with both the FORMULATOR and MANTIS, the two liquid handlers can be integrated so that non-precious reagents are dispensed with the FORMULATOR, and precious reagents are dispensed with the MANTIS.

 

Prerequisites

 

To run FORMULATOR experiment designs with MANTIS:

  1. Place the MANTIS chips into the chip pallets, and attach the chip pallet to a chip changer station.

  2. Attach the reagent tubes or pipette tips to the ingredient inputs at each chip.

Note: If you are using a pipette tip, you will need to remove the black adapter from the chip’s input.

  1. Place the microplate on the plate holder.

  2. Drag the reagent name from the Dispense List Designer panel to the corresponding inputs.

Drag Reagent to the Device Control Panel

  1. Attach your reagents to the MANTIS chips (if you are using pipette tips, you will need to remove the black adapter from the chip’s input first).

  2. Click to start the dispense process or click to run dispense with protocol.

  3. The MANTIS will complete your plate dispense design. You may now run Reagent Recovery (optional). When you are finished dispensing, clean the chips.

 

Related Topics


MAC-V47R321

10 DeAngelo Drive

Bedford, MA 01730

USA

 

+1-781-788-0228

support@formulatrix.com

publications@formulatrix.com